Idiomas disponibles
Idiomas disponibles
GB
GB
Mounting the tubular
shaft
Before mounting, remove the pro-
tective cap (9) from the front tubu-
lar shaft (2).
1. Loosen the butterfly screw (3).
2. Pull the lock (8) outward and turn it
left or right as far as it goes.
3. Slide the front tubular shaft (2)
onto the tubular shaft on the device
housing (4).
4. Pull the lock (8) outward and turn it
back to its original position.
5. Turn the front tubular shaft (2) with
a gentle rotating movement until the
lock (8) clicks into place in the bore on
the front tubular shaft (2).
6. Fix the tubular shaft in place with the
butterfly screw (3).
Only tighten the butterfly
screw (3) finger-tight. The use of
maximum manual force will da-
mage the tubular shaft.
Mounting the round
handle
The round handle (5) must be
mounted with a spacing of at
least 25 cm to the handgrip
(
27)!
The leg protection (7) must al-
ways be mounted on the opera-
tor side!
1. Place the round handle (5) onto the
tubular shaft of the device housing (4).
Choose a position within the level-
led adjustment range marked on
the bottom of the tubular shaft.
128
2. Position the leg protection (7) onto the
round handle (5) from below.
3. Fix the round handle (5) and the leg
protection (7) with the four hexagon
socket screws (30) using the hexagon
socket wrench (17) from the
storage (
28).
Mounting the protective
cover
The protective cover (1) must be mounted
to the front tubular shaft (2).
1. Screw the protective cover (1) to the
front tubular shaft (2) using the two
small Phillips screws (31). Use the
Phillips screwdriver (20) for this.
2. Fasten the cover (32) to the protective
hood (1). Use the hexagon socket
wrench (18) and the three screws (33).
Assemble the 3-tooth
blade
Whenever you use the 3-tooth
blade, the protective cover wi-
thout extension (
used. (See Chapter: "Removing/
mounting the protective cover
extension")
1. Remove the rechargeable batteries.
2. Place the device on the ground in a
stable position.
3. Block the mounting spindle (34) using
the hexagon socket wrench (18) as
depicted.
4. Place the 3-tooth blade (10) along
with the transport protection (11) onto
the uptake spindle (34). The blade can
be used on both sides.
5. Fasten the 3-tooth blade using the
thinner washer (35), conical spring
14) must be
