Tennant T981 Manual De Instrucciones página 16

Tilt the seat forward and the tank backwards, then place
the batteries in the compartment, positioning them as
indicated by the drawing on the battery box.
Connect the wiring terminals to the battery poles, tighten
and cover with Vaseline.
Close the tank into the working position.
When using the machine, follow the instructions below.
Selection of battery charger
! ATTENTION: check that the battery charger is
compatible with the batteries being charged.
Tubular lead-acid (wet) batteries: an electronic battery
charger is recommended. In any event, contact the
external battery charger is suitable.
for this type of battery.
Preparing the battery charger
! ATTENTION: authorized service technician required
to perform this procedure.
When using a battery charger not provided with the
the machine equipment package.
The connector supplied for the external battery charger is
suitable for cables with maximum cross-section 16 mm2
remove around 13 mm of the protective sheath from the
red and black conductors of the battery charger cable;
attach the ends to the contacts of the connector and
squeeze forcibly with suitable crimping pliers;
make certain the polarity is correct (red + black –) when
attaching the wires to the connector.
EN 16