SICK GTB20 Manual De Instrucciones página 26

OPERATING INSTRUCTIONS
en
5 Electrical installation
26 O P E R A T I N G I N S T R U C T I O N S | GTB20
0.6 ... 0.8 Nm
0.4 ... 0.5 Nm
0.8 ... 1.3 Nm
1
Figure 1: Tightening torque
See table 3 and table 4.
1
CAUTION
Please provide adequate strain relief externally for the cable if necessary. The back
cover must be completely sealed before operation.
Note the preferred direction of the object relative to the sensor, cf.
page 26.
Figure 2: Alignment of the sensor relative to the object direction
The sensors must be connected in a voltage-free state. The following information must
be observed, depending on the connection type:
– Male connector connection: Pin assignment
– Cable: Wire color
– Terminal connection: Pin assignment
Terminal connection:
1. Untighten the M3 screw on the back cover and remove the back cover.
< 0.4 Nm
see figure 2,
8026846.1GXN/2022-11-05 | SICK
Subject to change without notice