SWM SIX6 500 Manual De Instrucciones página 43

FRONT SUSPENSION COMPRESSION
ADJUSTMENT
You can adjust the hydraulics in the front suspension.
Standard calibration: 16 clicks
- To make the adjustment, act on the adjusters
(1) located on the lower part of the fork sleeves,
turning the adjusting screw (1) to "F" for softer
travel and to "S" for harder travel.
- To reset standard calibration, turn adjuster (1)
clockwise to reach the fully closed position; then,
turn it back by the mentioned clicks.
Note
Never force the adjusting screws beyond the
maximum open and closed positions.
CAUTION
a a
Both fork legs have to be adjusted in the
same way.
REAR SHOCK ABSORBER SPRING PRELOAD
ADJUSTMENT
The spring preload of rear shock absorbers (1) can
be adjusted; to make the adjustment, operate as
follows:
- Clean lock ring nut (2) and adjuster ring nut (3) of
the spring (4).
- Either with a hook wrench or an aluminium punch,
loosen the lock ring.
- Turn the adjuster ring nut as required.
- When the adjusting operation is over - according
to your weight and riding style - tighten the lock
ring nut.
a
WARNING
Be careful not to touch hot exhaust pipe
while adjusting the shock absorber.
CAUTION
a a
Both rear shock absorbers must be
adjusted in the same way.
SIX DAYS
43 -
EN