Poulan Pro 220 Manual De Instrucciones página 6

abnormal swellings. Prolonged use in cold
wea_ has been linked to blood vessel
damage in otherwise healthy people. If
symptoms occur such as numbness, pain,
loss of strength,change in skin color or texture,
or loss of fee_ingin the fingers, hands, or joints,
discontinue the use of this toot and seek
medical attention. An ant_wibration system
does not guarantee the avoidance of these
problems. Users who operate power tools on
a contthual and regular basis must monitor
closely their physical condition and the
condition of this tool.
SPECIAL NOTICE: Your saw is equipped
with a temperaturelimiting muffler and spark
arresting screen which meets the
requirements of California Codes 4442 and
4443. All U.S. forest land and the states of
California, Idaho, Maine, Minnesota, New
Jersey, Oregon, and Washington require by
law that many internal combustion engines
to be equipped with a spark arresting screen.
Ifyou operate a chain saw in a state or locale
wheresuch regulations exist, you arelegally
responsible for maintaining the operating
condition of these parts. Failure to do so is
a violation of the law. Refer to the SERVICE
section for maintenance of the spark
arresting screen.
Failureto follow all Safety Rules and Precau_
tions can result in serious in ury. ff situations
occur wh ch are not covered n th s manua,
use care and good udgement. If you need
assistance, contact your authorized service
dealer or call 1-800-554-6723.
STANDARDS: This saw is listed by Under*
writer's Laboratories, thc., and the Canadian
Standards Association in accordance with:
ANSI B175.1-2000 American National
Standard for Powered Tools - Gasoline
Powered Chain Saw - Safety Requirements
CSA Z62.1-03 Chain Saws - Occupational
Health and Safety
CSA Z62.3-96 Chain Saw Kickback Occu*
potional Health and Safety
Protective gloves not provided) should be
worn dur ng assemb y.
ATTACHING THE BAR & CHAIN (ff not
already attached)
_WARNING: If received assembled,
repeat all steps to ensure your saw is prop-
erly assembled and all fasteners are secure.
Always wear gloves when handling the
chain. The chain is sharp and can cut you
even when it is not moving!
1. Loosen and remove the chain brake nuta
and the chain brake from the saw.
2. Remove the plastic shipping spacer (if
present).
Location of shipping spacer
a_ Chain Brak_e
Ch Nuts
Bar Tool
3. Turn adjusting screw on bar counter-
clockwise to move the tensioning rack as
far as it will go toward the front of the bar.
o Adjusting
_;_ ctrew
Tensioning Rack ,J/_ "_
4. Slide the bar behind clutob drum until bar
stops against clutob drum sprocket.
5. Prepare the chain by checking the proper
direction. Without following the illustration it
is easy to _ace the chain on the saw in the
wrong direction. Use the illustr_ion of the
chain to determine the proper direction.
Tip of
Bar
DIIRECTION OF ROTATION
Cutters Depth Gauge
Drive Links
6