Idiomas disponibles
Idiomas disponibles
Installation
Installation requirements
Air quality
• For optimum performance and maximum product life we recommend the use of compressed air with a dew
point between +2°C and +10°C. Installation of an Atlas Copco refrigeration-type air dryer is recommended.
• Use a separate air filter of type Atlas Copco FIL, removes solid particles larger than 15 microns and more
than 90 % of liquid water, installed as close as possible to the product and prior to any other air preparation
unit like REG or DIM (please see Air Line Accessories in our main catalogue). Blow out the hose before
connecting.
Lubricated models:
• The compressed air must contain a small quantity of oil. We strongly recommend that you install an Atlas
Copco oil-fog lubricator DIM, to be set normally at 3–4 drops (50 mm
or an Atlas Copco single-point lubricator type Dosol for short cycle running tools.
For Dosol setting please see Air Line Accessories in our main catalogue.
Compressed air connection
T
WARNING Air under pressure can cause serious injury
Always shut off air supply, drain hose of air pressure and disconnect tool from air supply when not in use,
►
before making any adjustments to the product, e.g. changing accessories, or when making repairs.
Never direct air at yourself or anyone else.
►
T
WARNING Whipping hoses can cause serious injury
Always check for damaged or loose hoses and fittings.
►
Check air pressure:
• The product is designed for a working pressure (e) of 6–7 bar = 600–700 kPa = 87–102 psig.
• The air pressure at the tool inlet with the product running must not exceed the maximum operating pressure
7 bar = 700 kPa = 102 psig.
• Blow out the hose before connecting it.
8
EN
© Atlas Copco Industrial Technique AB - 9836 9882 00
3
)/min for long cycle running tools,
G2511-115
