Idiomas disponibles
Idiomas disponibles
(+ or -) is correct as indicated in
the battery compartment.
Reattach the battery compart-
ment cover
29
compartment.
Initial use
Note: The product has 3 operating
modes: cooling mode, dehumidifi-
cation mode and fan mode.
Unless otherwise described, you can
select all the settings listed below
using both the control panel
the remote control
Each time a button is pressed, an
acoustic signal sounds as confir-
mation.
Set up the product as described
in the chapter "Setting up the
product".
Plug the mains plug
perly installed grounded power
socket. Do not use extension
leads or multi-plugs.
Point the remote control
direction of the signal receiver
and make sure that there are no
obstacles between the two com-
ponents.
Note: You can control the direc-
tion of the air flow by moving the
lever on the ventilation slots
40 GB/IE
to the battery
and
1
(see fig. B or C).
11
into a pro-
10
in the
11
24
2
Using cooling mode
Press the POWER button
to switch on the product. The
product switches on and the
display
19
last set temperature.
Press the MODE button
repeatedly until the mode indica-
shows COOL. The product
tor
20
is now in cooling mode.
Now set the desired temperature
using the TEMP– button
TEMP+ button
ture range: 16 °C–31 °C). The
set temperature flashes on the
display
19
approx. 5 seconds.
Push the SPEED button
to adjust the fan speed. The fan
speed indicator
selected speed (HIGH or LOW).
To turn off the product, press the
POWER button
Using dehumidification
mode
Note: You can remove the hot air
outlet hose
13
operating in dehumidification mode.
For instructions on how to drain
the integrated water tank, see
the chapter "Draining the water
.
shows the pre-set /
(tempera-
26
and is saved after
shows the
17
.
27
from the product when
27
23
/
25
22
