Idiomas disponibles
Idiomas disponibles
EN
Governor Adjustment
When installing a new Governor Assembly, screw the Adjusting Nut onto the Stem to dimension "A" shown in Dwg. TPD497. This will usually
result in the proper governed free speed of the Spindle. However, this is only an approximate setting and, after checking with a tachometer,
further adjustment may be necessary. Screw the Nut farther onto the Stem to increase the speed; back it o to decrease the speed.
A=1–31/32" for Drills with Standard Throttle.
A = 1–7/8" for Motors equipped with Remote Control.
The correct governed free speed for the various Models at the Spindle is:
Models
22JA1–EU, 2XJA1–EU
22KA1–EU, 22KWA1–EU, 2XKA1–EU
22MA2–EU, 2XMA2–EU
22NA1–EU
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain condensate from valve(s) at low point(s) of piping,
air lter and compressor tank daily. Install a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any hose
coupling without internal shut-o , to prevent hose whipping if a hose fails or coupling disconnects. See drawing 47113980 and table on page
2. Maintenance frequency is shown in a circular arrow and de ned as h=hours, d=days, and m=months of actual use. Items identi ed as:
1.
Air lter
2.
Regulator
3.
Lubricator
4.
Emergency shut-o valve
5.
Hose diameter
6.
Thread Size
Oiler Adjustment
To adjust oiler, remove the Backhead and turn the Oiler Adjusting Screws . Turning the Screws in (clockwise) reduces the oil ow. Backing
the Screws out increases the oil ow. The oil ow can be controlled by turning either Screw.
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled, degreased and parts be separated by material so that
they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand O ce or Distributor.
EN-2
Speed, rpm
1,025
725
350
280
(Dwg. TPD497)
7.
Coupling
8.
Safety Air Fuse
9.
Oil
10.
Grease - during assembly
11.
Grease - through tting
A
03523024_ed25
