Turning Off The Power - Sony VPL-FH500L Manual De Referencia Rápida

Notes
• Be careful not to let the projector down on
your fingers.
• Do not push hard on the top of the projector
with the adjuster extended. It may cause a
malfunction.
• Since the Keystone adjustment is an
electronic correction, the image may be
deteriorated.
Displaying a pattern for adjusting
an image
You can display a pattern for adjusting the
projected image with the PATTERN key on
the Remote Commander. Press the
PATTERN key again to restore the previous
image.
12
GB
Projecting an Image

Turning Off the Power

1
Press the ?/1 key on the main unit or
the 1 key on the Remote Commander.
The message appears if you press the
1
key on the main unit. Press it again
according to the message.
The fan continues to run for a while to
reduce internal heat.
2
Unplug the AC power cord from the
wall outlet.
You may unplug the AC power cord
before the fan stops.
Note
To move the projector just after turning
it off, be sure to wait until the fan stops
before unplugging the AC power cord.
Unplugging the AC power cord before
the fan stops may cause a malfunction.
To erase the confirmation message
The message disappears if you press any key
?/1
other than the key on the main unit or
key on the Remote Commander, or if you do
not press any key for a while.
To turn off the power with the key
on the main unit without a
confirmation message being
displayed
?/1
Hold the key on the main unit pressed
for a few seconds.
?/
1