INSTALLATION
After you have purchased your gas bottle, you can start assembling your gas grill.
1. Make sure that you change the gas bottle away from other sources of ignition.
Position the gas bottle on the left side of the gas grill, making sure the container is in
a safe position out of reach of any heat source.
2. When ready to use the grill, insert the regulator into the gas cylinder valve and
tighten securely.
WARNING: Danger of fi re and explosion
Before attempting to light your gas grill, read the lighting instructions and
safety precautions. Before each use, inspect the hose for tears, cuts or
other signs of wear. Never use the gas grill if the hose is defective.
Make sure that there are no sources of ignition such as fi re, cigarettes,
open fl ames, etc. in the vicinity when changing the gas bottle. The device
must be switched off before changing the gas bottle.
• Make sure the hose is not twisted, as this may restrict gas fl ow when assembling
the gas grill. Furthermore, the hose must not be under too much tension or touch the
grill, as it can become very hot during use.
• Choose a hose that can withstand temperatures in excess of 80 °C.
• The fl exible hose should be changed every 2 years; if national regulations require
it, it must be changed more frequently.
Changing the Gas Bottle
Note: Turn off the cylinder's gas valve (a wrench is not required).
• When you insert the gas bottle into the holder of the gas grill, the height should be
less than 48 cm and the maximum width 33 cm.
• If you place the gas bottle outside the grill holder, the height should be less than 80
cm and the width should be a maximum of 3 cm.
Connecting a Gas Bottle
1. Rotate the orange cap so the arrow points to the gap in the cover.
2. Remove the orange protective cap by pulling out the safety guard. Do not use tools.
Let the cap on the gas bottle hang down.
3. Make sure the black O-ring is in the gas cylinder valve. Connect the regulator to
the valve.
4. Turn the regulator clockwise and turn on the gas grill as intended.
EN
23