Grundig Music 6500 Manual Del Usuario página 30

Idiomas disponibles
  • ES

Idiomas disponibles

SAFETY ___________________________________
This device is designed for the playback
of audio signals. Any other use is
expressly prohibited.
Make sure the device is protected from
dripping or splashing water.
Do not place any vessels such as vases
on the device. These may be knocked
over and spill fluid on the electrical
components, thus presenting a safety
risk.
Do not place any naked flames such as
candles on the device.
Only use the device in a moderate
climate.
Ensure that the device is adequately
ventilated by placing it at least 10 cm
from any other object. Do not cover the
device with newspapers, table cloths,
curtains, etc.
If malfunctions occur due to static
electricity charges or fast transient
(burst), reset the device. To do this, pull
out the power plug and connect it again
after a few seconds.
When deciding where to place the device,
please note that furniture surfaces are
covered by various types of varnish and
plastic, most of which contain chemical
additives. These additives can corrode
the device supports, leaving residues
on the furniture surfaces which can be
difficult or impossible to remove.
Do not use any cleaning agent, as this
may damage the casing. Clean the
device with a clean, dry cloth.
Never open the device casing. The
manufacturer will not accept any liability
for damage resulting from improper
handling.
Make sure the power plug is freely
accessible.
This equipment is a class II or
double insulated electrical
appliance. It has been designed
in such a way that it does not require a
safety connection to electrical earth.
RF Exposure Warning
This equipment must be installed and
operated in accordance with provided
manual. The device comprised a built-in
antenna and must not be co-located or
operating in conjunction with any other
antenna or transmitter.
The only way to completely disconnect
the device from the mains is to unplug
the mains cable.
Warning
Risk of fire/short circuit!
Rising steam or heat can pose a risk of
electric shock or fire if a short circuit
occurs.
Risk of explosion if the battery is replaced
by an incorrect type;
Disposal of a battery into fire
or a hot oven, or mechanically
crushing or cutting of a
ENGLISH
29
loading