Pasos
1. Place the heat sink on the system board.
2. Tighten the four or seven captive screws that secure the heat sink to the system board.
NOTA:
Tighten the captive screws in the sequential order mentioned on the heat sink [1 > 2 > 3 > 4] or [1 > 2 > 3 > 4 >5 > 6 > 7].
NOTA:
The number of screws varies depending on the configuration ordered.
3. Replace the two screws (M2x4) that secure the heat sink to the system board.
Siguientes pasos
1. Install the
base
cover.
2. Install the
SIM
card.
3. Follow the procedure in
Tarjeta madre
Removing the system board
PRECAUCIÓN:
The information in this section is intended for authorized service technicians only.
Requisitos previos
1. Follow the procedure in
2. Remove the
SIM
card.
3. Remove the
base
cover.
4. Remove the battery.
82
Extracción e instalación de unidades reemplazables en campo (FRU)
After working inside your
computer.
Before working inside your
computer.