Metabo PowerMaxx SSD Manual Original página 10

en ENGLISH
- ensure good ventilation of the workplace and keep
clean using a vacuum cleaner. Sweeping or
blowing stirs up dust.
- Vacuum or wash the protective clothing. Do not
blow, beat or brush.
5. Overview
See page 2.
1 Hexagon socket attachment for hexagon
screwdriving bits
2 Locking sleeve
3 LED light
For working on dimly lit areas. The LED lights
light up when the machine is switched on.
4 Rotational direction switch / Transporting safety
device
5 Trigger
6 Button for battery pack release
7 Battery pack
6. Initial Operation/Setting
Remove the battery pack from the machine
before any adjustment or maintenance is
carried out. Before fitting the battery pack, make
sure that the machine is switched off.
6.1 The machine's multifunctional monitoring
system
If the machine switches off automatically, the
machine electronics have activated automatic
protection mode. A warning signal sounds
(continuous beeping). The beeping stops after a
maximum of 30 seconds or when the trigger is
released (5).
In spite of this protective function, overloading
is still possible with certain applications and
can result in damage to the machine.
Causes and remedies:
1. Battery pack almost flat (the electronics
prevent the battery pack from discharging totally
and avoid irreparable damage).
If the battery pack is almost flat, it must be
recharged.
2. Long continuous overloading of the machine will
activate the temperature cut-out.
Leave the machine or battery pack to cool.
Note: The machine will cool more quickly if you
operate it at idling speed.
6.2 Battery pack
Charge the battery pack before use.
If performance diminishes, recharge the battery
pack.
Removing the battery pack
Press the battery pack release button (6) and
remove the battery pack (7).
10
To fit
Slide in the battery pack (7) until it engages.
6.3 Setting the direction of rotation,
engaging the transporting safety device
(switch-on lock)
Do not actuate the rotation selector switch or
engage the transportation lock (4) unless the
motor has stopped completely!
Actuate the rotational direction switch /
Engage the transportation lock (4)
R = Right rotation set
(insert screws)
L = Left rotation set
(remove screws)
0 = Central position: transportation lock setting
(switch-on lock)
6.4 Switching on and off
To switch on: press the trigger switch (5).
Switching off: Release the trigger (5).
6.5 Speed / Tightening torque
The speed and tightening torque are connected
directly. The lower the speed, the lower the
tightening torque.
Stepless adjustment of the tightening torque:
The speed and tightening torque can be adjusted
steplessly by pressing the trigger (5) firmly or lightly,
thus adapting to working conditions.
Recommendation: determine the correct setting
by carrying out trial screwdriving.
6.6 Changing screwdriver bit
Inserting screwdriving bit: Slide locking sleeve
(2) forward and insert screwdriving bit as far as the
stop. Release locking sleeve (2).
Pull on the screwdriver bit to check that it is
correctly seated.
Removing screwdriving bit: Slide locking sleeve
(2) forward and remove screwdriving bit.
Only use screwdriving bits with such plug-in
ends:
The screwdriving bit used must match the
screw.
Damaged screwdriving bits must not be used.
7. Use
Mount the machine on the screw, ensuring it is
aligned straight.