S&P AIRSENS WIFI CO2 Manual De Instrucciones página 13

platform, it is necessary to use the command "Obtain password" for its gene-
ration and validation. Make sure the mobile device and AIRSENS are connec-
ted to the same WIFI network.
(1) In case of an error in the connection, the WIFI network of the device will remain visible for
an hour. Try again.
(2) In case of having disabled 4G/5G mobile network, activate to be able to enter to website
address.
IMPORTANT: In case of many AIRSENS WIFI devices within the same range,
carry out a connection procedure to the WIFI network in a staggered and
individual way per device.
In case to link the AIRSENS WIFI device to a new WIFI network, when it has al-
ready been linked to another one, previously reset the WIFI antenna by pressing
the button located in the lower left corner for 5 seconds (see Fig.1). Then follow
the steps described above.
Operating modes (see Fig.2)
MF1: Relay + Connectair (reading) – [SW1-4=OFF]
Adjustable relay via P1 potentiometer. Factory settings: 1200 ppm / 70%HR
MF2: 0-10Vdc output analogue signal + Connectair (reading) – [SW1=ON,
SW2-4=OFF]
0-10Vdc output analogue signal adjustable via P1 potentiometer. Factory set-
tings: 1200 ppm / 70%HR
MF3: 2-10Vdc output analogue signal + Connectair (reading) – [SW1-2=ON,
SW2-4=OFF]
2-10Vdc output analogue signal adjustable via P1 potentiometer. Factory set-
tings: 1200 ppm / 70%HR
MF4: Connectair control – [SW1-3=ON, SW4=OFF]
Access to reading, edition and communication of working parameters via Con-
nectair. Relay and output analogue signal enabled. Factory settings: 1200 ppm
/ 70%HR .
Note: If other switch combination is chosen, LED diffuser is switched off and
digital/ analogue signals are inoperative.
AIRSENS WIFI devices have two LEDs aggrupation. Three on the main PCB board
and another four on the WIFI antenna (see Fig.1).
EN
13