Brita On Tap Manual De Instrucciones página 7

10. BRITA service
10. BRITA service
10.1 Troubleshooting
In the event of faults, please read the following potential
causes and their remedies. If the problem persists, con-
tact the authorized distributor for your country.
Problem Cause
Cannot attach
diverter to the tap.
Filtered water drips
out of the water
outlet even when the
tap is turned off.
Hot water was acci-
dentally run through
the filter for a short
time.
Water leaks from the
connection between
the diverter and the
tap.
Water leaks from
between the diverter
and the On Tap
housing.
Remedy
Determine whether you need an
adapter (see section "5. Installa-
tion/Step 2"). If the adapter does
not fit, please contact the official
distributor for your country.
There is still water under pressure
in the On Tap housing when the
tap is turned off. It is normal for
the filtered water flow to continue
for a few seconds.
A small amount of hot water run-
ning through the water filter will
not damage it. However, make
sure you always use cold water
for the filtering process.
A) Ensure that you have attached
the diverter to the tap correctly
(do not use any tools!).
B) If the tap has an internal
thread, ensure that the washer
has been fitted right at the top
of the adapter.
Please contact the BRITA service
hotline.
Problem Cause
Water leaks from
the side of the filter
cartridge cap.
The electronic
cartridge change
indicator lights do
not flash in filtering
position.
10.2 BRITA Quality Guarantee
For over 40 years, BRITA has stood for constant innova-
tion and the highest quality in the development of water
filter solutions. To justify high quality requirements at
BRITA there are stringent internal and external quality
controls.
10.3 BRITA Satisfaction Guarantee
BRITA is convinced that this BRITA product will satisfy
your demands of quality and performance. If you are not
completely satisfied with your BRITA product, BRITA
guarantees to give you your money back within 30 days
from date of purchase. Please call your local customer
service before sending your On Tap water filter System.
On Tap water filter system is warranted to be free from
defects in material and workmanship at the time of
delivery. Any warranty claims will be voided if defective
installation is deemed to have contributed to malfunc-
tion. Installation needs to take place in accordance with
the instructions and all relevant plumbing codes and
standards.
Our goods come with guarantees that cannot be
excluded under the Australian and New Zealand Con-
sumer Law. You are entitled to a replacement or refund
for a major failure and for compensation for any other rea-
Remedy
A) Ensure that the filter cartridge
cap has been tightened prop-
erly.
B) Check that the "O-ring" seat
inside the filter cartridge cap is
in the correct position.
A) Ensure that the battery has
been installed correctly.
B) The battery is exhausted.
See section "8. Changing the
battery" .
ENGLISH 11