Idiomas disponibles
Idiomas disponibles
press the decrease heat setting button
again.´L`will no longer be displayed and the
hob will be switched off.
Key Lock
The key lock function is used to set
'save mode' on the appliance during
operation. It will not be possible to make
any adjustments by touching the buttons
(for example heat settings). It will only be
possible to switch the appliance off.
The lock function is active, if the key lock
button
is pressed for at least 2 seconds.
This operation is acknowledged by a
buzzer. After successful operation, the key
lock Indicator flashes and the heater is
locked.
Timer Function
The timer function is available in two
versions:
Minute minder timer (1..99 min)
The minute minder timer can be operated
if the cooking zones are switched off. The
timer display shows ´00` with a blinking dot.
Touch
to increase the time or touch
to decrease the time. The range is between
0 and 99 minutes. If there is no adjustment
to the displayed time within 10 seconds,
the minute minder timer will be set and the
blinking dot will disappear.Once the timer is
set, it begins to count down.
When the timer reaches zero, a signal
sounds and the timer display blinks. The
sound signal stops automatically after 2
minutes and/or by pressing any button.
The minute minder timer can be changed
or switched off anytime by using the timer
setting button
and/or the decrease
timer button
. Switching off the hob by
touching
at anytime will also switch off
the minute minder timer.
Cooking zone timer (1..99 min)
When the hob is switched on, an
independent timer can be programmed for
every cooking zone.
Select a cooking zone, then select the
temperature setting and finally activate the
timer setting button
programmed to switch off a cooking zone.
Around the timer four LEDs are arranged.
These indicate which cooking zone the
timer has been set for.
10 seconds after the last operation, the
timer display changes to the timer that will
run out next (in cases where a timer is set
for more than one cooking zone).
, the timer can be
EN - 16
When the timer has run down, a signal
sounds and the timer display shows ´00`
and, the assigned cooking zone timer LED
blinks. The programmed cooking zone will
be switched off and the ´H` will be displayed
if the cooking zone is hot.
The sound signal and the blinking of the
timer LED will be stopped automatically
after 2 minutes and/or by operating any
button.
Buzzer
While the hob is in operation, the following
activities will be signalled by the buzzer:
•
Normal button activation will be
accompanied with a short sound signal
•
Continuous button operation over a
longer period of time (10 seconds)
will be accompanied with a longer,
intermittent sound signal.
Boost Function
To use this function, a cooking zone must
be selected,with the desired cooking level
set. Then press the P(Boost) button.
The Boost function can only be activated
if it is applicable with the cooking zone
selected If Boost Function is active a ´P` is
shown on the corresponding display.
Activating the booster can exceed the
maximum power, in which case the
integrated power management will be
activated.
The necessary power reduction is shown
by the corresponding cooking zone display
blinking. Blinking is active for 3 seconds
and allows further adaptations of the
settings before power reduction.
