Schulz FI650 Manual De Instrucciones página 24

Idiomas disponibles

Idiomas disponibles

• 10. Make sure the power trigger is in the "off" position and remove the finger from the trigger
before connecting the tool to the power grid.
• 11. The tool model must be chosen in compliance with the established use. Do not force your
equipment excessively. If required, acquire a more suitable tool for the application. This will
increase the efficiency and safety in the work;
• 12. Never use your tool with your weight on it, forcing the equipment.
• 13. Do not make holes on power cords, gas or water pipes. Contact with water or electric wires
may cause electric shock. The electric motor of the tool generates sparks which in contact with
flammable gases may cause an explosion;
• 14. Fastening of the part: to avoid accidents, always fasten the part properly before starting
drilling, especially small parts. If required, use clamps.
• 15. Use your tool only for the purpose it was designed, according to the intended use described
in this manual. Do not use it for other purposes;
• 16. Do not expose your power tool to rain or wet conditions. Contact with water will increase
the risk of electrical shock;
• 17. Remove all adjustment tools before turning your equipment on. A tool or part stuck in moving
of the equipment may cause serious injuries;
• 18. Avoid touching the tip of the drill right after the drilling because it may be hot.
Workplace and Point of Use:
- Keep the place clean, tidy and illuminated.
- In order to avoid distractions and accidents, after using your tool, isolate the workplace to prevent access
of visitors, children or animals.
- Power outlet must be compatible to the tool plug. To reduce the risk of shock, do not change the plug cha-
racteristics and do not use adapters. If required, replace the outlet with a plug suitable model.
ATTENTION
extension cords may increase the risks of electric shock and damage the equipment.
Only use extension cords with impact resistance, insulation and suitable section
(minimum section of 1.0 mm², maximum 15-meter long). Use of inappropriate
24
loading

Este manual también es adecuado para:

Fi710