Idiomas disponibles
Idiomas disponibles
Figure 11. DC power connector and wiring block
1.
Wiring block
3.
PSU connector
1.
Strip a 1/2 inch section of insulation from each of the power connector's wires, as
shown.
2.
Insert each of the power connector's bare wire lengths into the wiring block. The blue
wire is -48V, the black wire is the positive return, and the yellow/green wire is the
ground wire, as shown.
3.
Use a flat-blade screwdriver to tighten the screws that secures the bare wires into
the wiring block.
4.
Secure the site's DC power source wires to the other side of the wiring block, see
steps 1 and 3.
2.
Power connector
21
