Idiomas disponibles
Idiomas disponibles
ADDITIONAL SAFETY
RULES FOR CIRCULAR
SAW
1.
Only use saw blades recommended in the
specification.
2.
Do not use any abrasive wheels.
3.
Use only blade diameter(s) in accordance with the
markings.
4.
Identify the correct saw blade to be used for the
material to be cut.
5.
Use only saw blades that are marked with a speed
equal or higher than the speed marked on the tool.
SYMBOLS
To reduce the risk of injury, user must
read instruction manual
Double insulation
Warning
Wear ear protection
Wear eye protection
Wear dust mask
EN
OPERATION
INSTRUTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The tool is intended for ripping and cross-cutting wood and
other materials in straight cutting lines, while resting firmly
on the work piece.
ASSEMBLY AND ADJUSTING
1. CHANGING A SAW BLADE (SEE FIG. A1,
A2)
WARNING:
• Unplug the saw before operation.
• Wear protective gloves when mounting
the saw blade. Danger of injury when touching the
saw blade.
• Only use saw blades that correspond
with the characteristic data given in the
operating instructions.
• Do not use grinding discs as the cutting
tool under any circumstances.
• When mounting, ensure the cutting
direction of the teeth (direction of arrow
on saw blade) and the direction of rotation
arrow above the blade guard match.
For changing the cutting tool, it is best to place the machine
on the face side of the motor housing.
- Removing
1) Press the spindle lock button and keep it depressed.
The spindle lock button may be actuated only when the
saw blade is at a standstill.
2) Push the lower guard lever counterclockwise to the left
side, and the lower blade guard runs synchronously.
Hold the guard firmly with the lower guard lever.
3) Loosen the blade bolt in clockwise direction with the
hex key provided. Remove the blade bolt, outer flange
and the saw blade.
- Mounting
1) Clean the saw blade and all the clamping parts to be
assembled. Depress the spindle lock button and keep it
depressed.
2) Push the lower guard lever counterclockwise to the left
side, and the lower blade guard runs synchronously.
Hold the guard firmly with the lower guard lever.
3) Place the blade onto the inner flange and then insert
the outer flange over the spindle and tighten the blade
securing bolt (turning counter-clockwise) with 1/4 turn
17
