cecotec Cumbia POWER MATIC-CCINO CREMMA Manual De Instrucciones página 26

ENGLISH
container's. Depending on the size of the container (height and width), you can remove
the drip tray as shown in figure 6.
Press the strong coffee (20) or mild coffee (21) button based on your preference.
4.
The coffee button you press will light up, indicating the appliance is preparing coffee.
5.
Once the machine goes back to Standby mode, the coffee will be ready for drinking.
6.
Preparing cappuccino
Assembling the automatic milk-frothing system. Fig. 7
Place the rubber connector piece in the recess on the inside of the cover.
1.
Insert the milk tank's inner tube into the rubber connector piece on the inside of the cover.
2.
Insert the milk-tank connector tube into the rubber connector piece on the outside of the
3.
cover.
Remove the cap from the cappuccinatore inlet and insert the mil-tank connector tube
4.
into the inlet.
Fill up the milk tank and close the cover. Press the On/Off button to switch on the machine
5.
and make sure the drip tray is located under the coffee spout and there is water in the
water tank.
Place a container under the spout.
6.
Press the cappuccino button (22): it will light up indicating cappuccino is being prepared.
7.
The indicator will remain lit during the preparation process.
The coffee machine will first dispense milk and then coffee.
8.
Preparation will stop automatically. If you want to stop it, press the cappuccino button
9.
again during operation. You can stop milk and coffee preparation separately by pressing
the button during each preparation.
10. Remove the milk tank from the appliance by disconnecting the connector tube from the
cappuccinatore inlet and place it in the refrigerator.
11. After use, see the section 'Daily cleaning of the appliance' to clean the automatic milk-
frothing system.
Please note
- Clean the automatic milk-frothing system before first use.
- Use cold milk (at a temperature of approximately 5 °C/41 °F) with fat content of at least 3%
to ensure optimal foam results.
Warning
- When preparation starts, the appliance may splash hot milk or emit steam.
- Place the milk-tank connector tube around the milk-tank cover after each use. Do not drop
it, as it may spill milk due to the pressure difference.
50
POWER MATIC-CCINO CREMMA
Preparing latte macchiato
Install the automatic milk-frothing system as described in the section 'Preparing cappuccino'.
Fill up the milk tank and close the cover. Press the On/Off button to switch on the machine
1.
and make sure the drip tray is located under the coffee spout and there is water in the
water tank. The appliance will perform an automatic rinse and flush out an amount of
water equivalent to a small cup. You can cancel this process by pressing the hot-water
button.
Place a container under the spout.
2.
Press the latte-macchiato button (23): it will light up to indicate that a latte macchiato is
3.
being prepared. The indicator will remain lit during the preparation process.
The coffee machine will first dispense milk and then coffee.
4.
Preparation will stop automatically. If you want to stop it, press the button again during
5.
operation. You can stop milk and coffee preparation separately by pressing the button
during each preparation.
Remove the milk tank from the appliance and place it in the refrigerator.
6.
After use, see the section 'Daily cleaning of the appliance' to clean the automatic milk-
7.
frothing system.
Please note
Use cold milk (at a temperature of approximately 5 °C/41 °F) with fat content of at least 3% to
ensure optimal foam results.
Warning
- When preparation starts, the appliance may splash hot milk or emit steam.
- Place the milk-tank connector tube around the milk-tank cover after each use. Do not drop
it, as it may splash milk due to the pressure difference.
Preparing frothed milk
Install the automatic milk-frothing system as described in the section 'Preparing cappuccino'.
Place a container under the spout.
1.
Fill up the milk tank and close the cover.
2.
Connect the milk-frothing system to the appliance.
3.
Press the frothed-milk button (24). The indicator light will turn on during preparation.
4.
After use, see the section 'Daily cleaning of the appliance' to clean the automatic milk-
5.
frothing system.
Please note
Use cold milk (at a temperature of approximately 5 °C/41 °F) with fat content of at least 3% to
ensure optimal foam results.
ENGLISH
51
POWER MATIC-CCINO CREMMA