Idiomas disponibles
Idiomas disponibles
Cabinet Construction and Features
5/8" 7-ply, Maple or Birch plywood construction, waterproof glue.
All joints Dado and Rabbet, glued.
Front Slot Port designed to eliminate unwanted noise
Heavy Duty Removable Casters
Heavy Duty Spring Handles
Midnight Blue Carpeting with Stack Lock Corners
Midnight Blue Stamped Steel Vibration-Free Grill
Dimensions
23"W x 23"H x 16.75"D
Weight
76 lbs.
WORKINGMAN'S 2X10C - GETTING STARTED
Remove the AC cable from the accessory pack and connect it from the amplifier to a standard wall outlet. Make sure that the "Gain"
and "Master Volume" controls are set to the minimum position (fully counter-clockwise). Locate the power switch on the right side of
the front of the unit and turn the amplifier on. Upon powering up, don't be surprised if you hear a small pop. This is absolutely normal
and will not cause damage to your speaker system.
(Eliminating this "power on transient" would require a component called a relay. SWR chose not to incorporate this type of compo-
nent due to the fact that relays degrade signal quality and often fail, causing the unit to have no output and requiring a trip to a local
service center. If you wish not to hear the pop upon power up, locate the "Speakers On/Off" switch on the front panel and set it to the
down position before you turn the unit on. Be sure to remember to set the switch back to "On" afterwards, or you may find yourself
wondering why you don't hear anything.)
Plug your instrument into the desired input jack (refer to "Front Panel Features" for greater detail). Turn your instrument's volume up
to at least 75% of maximum and slowly adjust the gain control. Once you begin to play your instrument and you see the red light
(marked "preamp clip") over the gain control illuminate, back off the gain a bit. Now turn up the "Master Volume" and you should hear
the sound of your instrument amplified through the Workingman's 2x10C. For more detailed information, please read the entire manu-
al carefully so that you can fully realize the potential of your new Workingman's 2x10C.
For those who wish to use an extension speaker cabinet with the Workingman's 2x10C, please skip ahead to the section marked
"Extension Speaker Output Section."
8 • WORKINGMAN'S 2X10C
