Denon AVR-X1200W Manual Del Usuario página 234

Contents Connections
o Cannot connect to a wireless LAN network
Symptom
Cannot connect to the
0
network.
0
0
0
Cannot connect to WPS.
0
0
0
0
Cannot connect to the
0
network using iPhone/iPod
0
touch/iPad.
Front panel Display
Playback
The network name (SSID), password and encryption setting have not been set up correctly. Configure the
network settings according to the setting details of this unit.
Shorten the distance from the wireless LAN access point and remove any obstructions to improve access
first before re-connecting again. Place the unit away from microwave ovens and other network access
points.
Configure the access point channel settings away from channels that are being used by other networks.
This unit is not compatible with WEP (TSN).
Check that the WPS mode of the router is operating.
Press the WPS button on the router and then press the "Connect" button displayed on the TV within 2
minutes.
A router/settings that are compatible with WPS 2.0 standards are required. Set the encryption time to
"None", "WPA-PSK (AES)" or WPA2-PSK (AES).
If the router encryption method is WEP/WPA-TKIP/WPA2-TKIP, you cannot connect by using the WPS
button. In this case, use the "Scan Networks" or "Manual" method to connect.
Update the iPhone/iPod touch/iPad firmware to the latest version.
When using a USB cable to configure the settings, the iOS device firmware version needs to support iOS
5 or later. When configuring the settings via a wireless connection, iOS 7 or later needs to be supported.
Rear panel
Settings
Cause / Solution
234
Remote
Tips Appendix
Page
Index
200
－
－
－
－
－
200
－
－
－