Denon AVR-X1200W Manual Del Usuario página 179

Contents Connections
5
Select "Start", then press ENTER.
Audyssey ® Setup can also make the following settings.
Amp Assign
0
The signals output from the SURROUND BACK speaker
terminals can be switched in accordance with your speaker
environment. ("Amp Assign" (v p. 186))
Channel Select
0
If channels that are not to be used are set in advance,
measurement for the set channels is skipped, and measuring
time can be reduced. You can also change the number of
surround back speakers and subwoofer.
Dolby Sp.Setup
0
Set the distance between the Dolby Atmos Enabled speaker and
the ceiling.
This can be set when "Assign Mode" is set to "Front Dolby" or
"Surround Dolby" in the "Amp Assign" settings. (v p. 186)
Front panel Display
Playback Settings
6
Follow the instructions on the screen display and press
"Next" to proceed further.
7
When the following screen is displayed, select "Begin
Test" and then press ENTER.
Start the measurement of the first position.
0 If "Caution!" is displayed on TV screen:
179
Rear panel
Tips
Audyssey Setup
Place the microphone at ear level at the main listening position.
Make sure you are always 20 inches (50cm) from the back
wall of your room for each test.
Ear Height
Back
Measurement requires several minutes.
0
NOTE
0 Go to "Error messages" (v p. 184). Check any related items, and
perform the necessary procedures.
Remote Index
Appendix
Next