Idiomas disponibles
Idiomas disponibles
Procedure
Check the engine oil level
Check the general condition
of the machine
Check the technical condition
of the chain
Lubricate the surface of the
slide rail
Check the drive belts
Lubricate the gear and rack
Check tire pressure
Clean the outer part of the
engine
Change engine oil
Replace the air filter
Replace the spark plug
Engine maintenance
The spark plug should undergo a technical inspection after every 100
hours of operation. Check the colour of the deposit at the end of the
spark plug. The colour should be brown. Remove the residue using a hard
brush. Check the distance between the electrodes and adjust it if
necessary. The correct distance is 0.7 to 0.8 mm.
Replacing the engine oil
Place the machine on a flat surface, switch it on and warm up the engine
for a few minutes. Unscrew the oil tank cap.
Unscrew the oil tank cap. Place a container to collect the waste oil
underneath the engine. Remove the oil drain screw and drain all the oil.
To protect against oil dripping into the frame of the machine, it is
recommended to use a pipe to bring the oil directly into the waste oil
container.
Check the drain screw, gasket, oil plug and ring. If these parts are
damaged or worn, they must be replaced. Replace and tighten the drain
Before each
use
X
X
X
X
X
After the first 5
hours
Every 3
Every 25
hours.
hours.
X
X
X
X
X
Every
100
hours
X
