Idiomas disponibles
Idiomas disponibles
Refuelling
a) Make sure the machine is turned off and that the engine has been
cooling down for at least 2 minutes before you start refuelling. Refuel
only outdoors.
b) Unscrew the fuel tank cap [F]
c) Fill the fuel tank up to a maximum of 15mm below the top of the tank.
Don't overfill!
d) Close the fuel tank cap [F].
Topping up engine oil
a) Make sure that the machine is standing on a level surface.
b) Check the oil level using the dipstick [J].
c) If the oil dipstick shows low oil level, top up using 10w-30/10w-40/15w-
30/15w-40 non-synthetic engine oil.
d) Fill in the oil through the same hole as the dipstick [J].
e) When topping up the oil, check the oil level so that it falls between L
(low level) and H (high level). Don't overfill!
Please note: Before using the machine, top the oil up to the correct
level. The engine is delivered without oil. Operating the engine without oil
or with a low oil level will damage the engine.
3.3.
Starting the engine
Always stand behind the machine when starting the engine, away from the
side worm and digging chain. Always start the machine at the work site and
then let it warm up. Each time the machine is started, check that all the
controls are working properly.
1. Make sure the depth adjustment arm is set to "0"
2. Make sure that the machine is refilled with engine oil and fuel.
3. Set the fuel supply valve [B] to ON.
Device use
