Idiomas disponibles
Idiomas disponibles
WORKING HINTS FOR
YOUR TOOL
• Reduce the pressure on the drill bit when it is about to
break through. This will prevent the drill from jamming.
• When drilling a large hole, first drill a pilot hole using a
smaller drill bit.
• Always apply pressure to your drill bit in a straight line,
and if possible at right angles to the workpiece.
• Never change the operating mode whilst the drill is
running.
• Do not apply excessive pressure to the tool when
chiseling. Expressive force does not speed up the work.
MAINTENANCE
1. Always grease the shank end of bits before insertion.
2. Never use water or chemical cleaners to clean your
power tool. Wipe clean with a dry cloth.
3. Always store your power tool in a dry place.
4. Keep the motor ventilation slots clean.
5. If you see some sparks flashing in the ventilation slots,
this is normal and will not damage your power tool.
6. If the supply cord of this power tool is damaged, it must
be replaced by a specially prepared cord available
through the service organization.
TROUBLESHOOTING
1. If your hammer does not start, check the plug on the
mains supply first.
2. If your hammer becomes too hot in use, set the hammer
switch to the drill mode and allow your drill to operate at
maximum speed without load for 2 minutes.
3. If your hammer work efficiency is too low, please add
sufficient grease in the grease box.
4. If your hammer use in low efficiency, please check
whether the tool is blunt.
5. If a fault can not be rectified return the tool to an
authorized dealer for repair.
14
EN
