Wesco WS3203K Manual De Instrucciones página 13

Idiomas disponibles

Idiomas disponibles

SYMBOLS
To reduce the risk of injury, user must read
instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Double insulation
Warning
EN
OPERATING
INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
Intended Use
The machine is intended for hammer drilling in concrete,
brick and stone as well as for chiseling work.
1. Adjusting the auxiliary handle (See Fig. A1,
A2)
For your personal safety we recommend using the auxiliary
handle at all times.
To adjust the handle, loosen the bottom of the handle anti-
clockwise and rotate the handle around the handle collar
until the handle is in the desired position. Tighten fully.
2. Fitting SDS tools (See Fig. B1)
Clean the bit shank and apply grease before installing the
bit. Hold the rotary grip, pull back the lock sleeve and insert
the SDS tool into the bit holder. Turn the bit and push it in
until a resistance is felt, the shaft drops completely into
bit holder. Once you are satisfied it has seated, release
the black lock sleeve. This should lock the SDS tool into
position.
After installing always make sure that the tool is securely
held in bit holder by trying to pull it out.
If the SDS tool is not located repeat the installation operation
again.
3. Removing SDS tools (See Fig. B2)
To remove the tool, pull back the locking sleeve, hold and
pull the tool out.
4. Operating the On/Off switch (See Fig. C)
Depress the switch to start the tool and release it to stop
your tool.
5. Operating the lock-on button (See Fig. C)
Depress the On/Off switch then the Lock-on button. Your
switch is now locked on for continuous use. To switch off
your tool just depress and release the On/Off switch.
6. Lubrication the machine (See Fig. D)
The machine is grease-lubricated. A grease refill is only
required during hammer work efficiency is low. Open
the grease box cover at the top of the hammer using the
spanner provided. Then refill approx 30g grease provided
with your tool. The grease specification is general purpose
lithium based.
CAUTION: Keep the container of grease
away from children.
13
loading