Idiomas disponibles
Idiomas disponibles
How to Hang and Wire Your Ceiling Fan
4.
Hang the motor assembly from the ceiling bracket
assembly using the hook on the ceiling bracket assembly
and the cable loop from the motor assembly as shown.
(Figure 6)
5.
Make sure the electrical supply wires, including the
ceiling bracket grounding wire are pulled through the
center hole of ceiling bracket, between the ceiling bracket
and the motor assembly so that electrical connections
can be made later.
NOTE: If fan or supply wires are different colors than
indicated, have this unit installed by a qualified electrician.
6. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote control.
(Figure 7)
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference
from or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: Factory setting is all up. Do not use this
position.
Ceiling Bracket
Assembly
Motor
Assembly
NOTE: Supply wires and
fan wires omitted for clarity
Dip Switch
ON
1
2
3
4
Remote Control
Dip Switch
8
(Continued)
Figure 6
Receiver
5
Figure 7
