Idiomas disponibles
Idiomas disponibles
Downloaded by: pd-oliana on 04-04-2023 14:44 CEST
- It is recommended that the brush to be used
when steaming delicate garments or when the
steamer brush is direct contact with fabric.
- Attention: always let the steamer cool
down before assembling or removing the
attachments.
ASSEMBLY OF ACCESSORIES:
1. Align the bottom protruding part o the
accessory into the bottom groove of the steam
head.
2. Push the head of the accessory until the top
protruding part also clicks in the top groove of
the steam head f
SAFETY THERMAL PROTECTOR:
The appliance has a safety device, which
protects the appliance from overheating.
If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
DECALCIFICATION
- If the appliance begins to begins to produce
steam more slowly than, or stops producing
steam and then starts again, you may need to
decalcify your steamer. Decalcification refers to
removing the calcium deposits that form over
time on the metal parts of the steamer. For
best performance from the Garment Steamer,
please decalcify the unit from time to time. The
frequency depends upon the hardness of the
water being used and how often you use the
steamer.
METHOD:
1. To decalcify, use water
2. Plug the unit into electrical outlet. Wait until
the red light goes off then push the steam
button, Release the steam button, unplug
from electrical outlet, and allow to cool for 30
minutes.
- Repeat the above procedure as many times
as necessary until a normal steam rate returns,
usually 2 to 3 times. With each repeated cycle,
use a fresh solution of water.
- Run one cycle of distilled water through the
unit at the completion of decalcification before
using the product again.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
