Idiomas disponibles
Idiomas disponibles
Welcome
Read these installation instructions thoroughly before
installing the device.
During installation, make sure that you also observe the
legal and local regulations of the country in which the
device is to be installed.
Mercedes-Benz is continuously enhancing and refining
its products and so reserves the right to introduce
changes to the following:
•
Design
•
Equipment
•
Technical features
Safety notes
G
DANGER – RISK OF FATAL INJURIES
WHILE WORK IS BEING PERFORMED ON
THE WALLBOX
If the wallbox is installed, maintained, repaired or
dismantled by personnel who are not suitably
qualified, this may result in e.g. a fire or an electric
shock.
Have this work performed by a qualified electrician
only.
Ensure that the power supply to the domestic electrical
installation is interrupted before starting installation.
Liability
In the event of improper installation of the device,
Mercedes-Benz disclaims any liability for damage that
may occur and the warranty for the device is rendered
invalid.
Scope of delivery
Country-specific deviations are possible.
1 Cover (variant A)
2 Wallbox with socket (variant A)
3 Cover (variant B)
4 Wallbox with permanently attached charging cable
(variant B)
5 Wall bracket
6 Installation kit
•
3 x plug, 8 x 65 mm
•
3 x T20 screw, 6 x 70 mm
•
3 x washer
•
2 x T20 TR screw, 4 x 12 mm
•
1 x T20 TR bit
7 Top cable duct
•
1 x cable duct
•
1 x blind plug for cable duct
•
1 x cable duct seal
Installation requirements
Note the following before starting installation:
•
Check the scope of delivery for damage. If you find
any damage, do not install the wallbox.
•
To configure the wallbox, it must be connected to
the Internet ( page 15).
•
At the installation site, the wallbox should be
protected from adverse weather conditions such
as direct sunlight, extreme temperatures, heavy
rain, etc.
•
The wall on which you intend to install the wallbox
must be smooth and have a sufficient load-bearing
capacity.
The mains cable is fed into the wallbox through the
underside as standard.It is possible to insert it from
above, but only when the device is installed indoors.
Power supply requirements
Earthing system
TNS system
TT system
IT system
Power consumption (phase)
Single-phase
Three-phase
Three-phase
-Automatic circuit breaker (MCB)
Installation: In accordance with IEC 60364 and all
applicable local regulations
Tripping characteristics: Type C
Rated current: 125% of the maximum current
configured for the wallbox
-The automatic circuit breaker should correspond
to the ampere settings of the wallbox and the
maximum current available to the wallbox; the
technical data from the MCB manufacturer is to be
taken into account here.-
- 9 -
PE cable
Separately installed earth
electrode (self-assembly)
230 V +/- 10% 50/60 Hz
230 V +/- 10% 50/60 Hz
400 V +/- 10% 50/60 Hz
