Changing The Configuration Program - TECNOMOTOR 810 Manual Operativo

The sw installation phase starts.

4.2 Changing the configuration program

Changes to the configuration program may only be carried out by
authorised technicians.
After installation of the program on the Computer, the appropriate settings
must be made in the configuration program.
Some images of the new configuration interface are shown here below.
CAUTION
These operations will be carried out only by authorised personnel. The
manufacturer is not liable for problems caused to the Computer and to the
instruments by unauthorised personnel.
To start the configuration phase of the various equipment connected to the
PC, use the mouse to double click on the icon displayed below, previously
created during the installation of the program
The following images are an example of the configuration interface
Once installation is completed, press
Finish.
14