Analyser Configuration; Setting Workshop Data; Setting Time And Date - TECNOMOTOR 810 Manual Operativo

3.3 Analyser configuration

Access the configuration menu when you want to make some setting changes
(change date and time) and every time you change the configuration used (e.g.
if you switch from the inductive clamp revolution counter to the M.C.T.C.NET
revolution counter).

3.3.1 Setting workshop data

During the initial message when the instrument is switched on, press the F
key, or press "ESC" twice if you are on the test type selection page. The menu
shown in the figure below will appear.
Select Setup and press the confirmation key ( ).
Select "Workshop data", and press the confirmation key
( ).
Select the workshop related items, and select them by
pressing the confirmation button ( ).

3.3.2 Setting time and date

During the displaying of the initial message when the instrument is switched on,
press the ESC key or the F function key, or from the main menu of the
instrument press the ESC key twice.
Select Setup and press the confirmation key ( ).
Select "Time and Date", and press the confirmation key
( ).
To change the time select "Time", and press the
confirmation key ( ).
►Setup
Service
11
►Setup
Service
Contagiri
Ora e Data
►Dati Officina
...
►Nome Officina
Indirizzo
Città
...
►Setup
Service
Revolution
counter
►Time and Date
Workshop Data
...
►Time
Date