Idiomas disponibles
Idiomas disponibles
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products' packaging has
been removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
INTERCHANGEABLE HEADS (FIG 1):
- To put a head, place the head tab in the guide
of the appliance. (Fig. 2) and close it till it fits
correctly.
U BLADE (2)
- Suitable for trimming beard, moustache and
sideburns.
- It can be used with or without guide comb 1,
depending on the desired cutting height.
PRECISION BLADE (3)
- Suitable for precision trimming, to achieve a
perfect finish or making "drawings" on hair.
- It can be used with or without guide comb 1,
depending on the desired cutting height
NOSE/EAR TRIMMING HEAD (4)
- Suitable for trimming hair from the nose and
ears.
IMPORTANT: do not insert it more than 5 mm
inside the nose or ears.
- Slowly move in and out while the trimmer revol-
ves to remove the unwanted hair. For improved
results, ensure that the end of the trimming
head touches the skin. This will reduce the
tickling sensation that can be caused by nasal
hair.
INSERTION OF A COMB GUIDE:
- Hold the guide comb by the two sides, insert
the head into the guides (Fig. 3), or pressing on
the comb release button (10) for guide combs
8 and 9 (Fig.4), and slide downward until it is
coupled.
- Use the comb size selector to adjust the height
of the cut.
- To extract the fixed comb guide (7), just pull
out.
- To remove the guide combs (8 & 9), press and
hold the comb release button (10) and pull
upward.
USE:
- The appliance can be used directly connected
to the mains or by using his batteries.
- If you want to use the device connected to the
mains, extend the cable completely before
plugging it in.
- Connect the appliance to the mains.
- Select the desired cutting height using the
comb height selector. Press it and adjust the
height according to the desired cutting length.
- The appliance gives to you the choice of trim-
ming or shaving.
COMB TO TRIM BEARD:
- Use the guide combs (7, 8, 9) depending on the
desired cutting length.
- Cut the hair moving the appliance in the oppo-
site direction of the natural growth of the hair.
- Always ensure that teeth of the comb guide are
pointing in the direction in which the appliance
is moving.
- Avoid clogging the comb with hair. Remove and
clean it from time to time.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Unplug the appliance from the mains.
- Clean the appliance.
- To keep the trimmer working properly, oil it with
light machine oil after each use.
CLEANING:
Disconnect the battery charger from the mains
and allow it to cool before undertaking any clea-
ning task.
WARNING: Detach the hand-held part from the
supply cord before cleaning it in water.
- Dismantle the appliance following these steps:
- Remove the fixed guide comb (7) by pullig it
upwards or guide combs 8 or 9 by using the
comb release button (10).
- Hold the appliance with one hand and use the
thumb to press blades while holding the plastic
part with the index finger until the blades come
out (Fig.5).
- Use the cleaning brush (13) to remove the hair
from inside the appliance and the blades.
