Cardin Elettronica S504 Manual De Instrucciones página 13

Transmitters 433 MHz
TXQ504C2
TXQ504C4
TXQPRO504-4
TXQPRO504-4A
Radio programmer 433 MHz Radio programmer 868 MHz Description
RPQ504RNA0
Memory module ZGB24LC64-I/P
The module is furnished with a none-volatile EEPROM type memory and contains the transmitter codes and
allows you to memorise up to 1000 codes. The programmed codes remain stored even in the absence of power.
Attention! Removing and inserting the memory module must be carried out when the receiver is switched
off otherwise the memory content could become corrupt.
PREPARING THE SYSTEM
To obtain the best results from the radio control system the aerial installation site should be carefully chosen.
'Range' is intended to mean the working distance, measured in free space, between the receiver and the
transmitter with the aerial installed. The range is therefore closely linked to the technical characteristics of
the system and varies according to the characteristics of the site in which the system is located.
For best performance we advise you to use the Cardin ANS400 / ANQ800-1 aerial. Wire the aerial to the
receiver using a coaxial cable RG58 (impedance 50Ω) with a maximum length of 15 m.
Transmitters 868 MHz
TXQ508C2
TXQ508C4
TXQPRO508-4
TXQPRO508-4A
RPQ508RNA0
Description
2-channel precoded transmitters
4-channel precoded transmitters
4-channel precoded industrial transmitters
4-channel precoded industrial transmitters + aerial
Radio programmer for rolling shutters
13