Cardin Elettronica S504 Manual De Instrucciones página 15

Electrical connection (fig. 1)
Before connecting the device to the mains make sure that:
- the voltage and frequency rated on the data plate conform to those of the mains supply;
- an all pole circuit breaker which leaves at least 3 mm between the contacts has been installed between
the device and the mains;
- the high voltage 230V wires pass through the holes marked "A" and are routed separately from the low
voltage wires which pass through the holes marked "B";
- the wires are fastened down using a cable clamp.
Caution: only low voltage circuits may be wired to the external circuit binding posts 1...6.
1 Outer conductor for radio receiver antenna
2 Inner conductor for radio receiver antenna with a 17 cm piece of rigid wire (if an external antenna is
fitted use a coaxial type cable RG58 with an impedance of 50Ω)
3 Anemometer input
4 Common for all inputs
5 Closing button input (N.O.)
6 Opening button input (N.O.)
7 Motor output (closing)
8 Motor output (opening)
9 Motor output (neutral)
10-11 Power supply 230 Vac 50-60 Hz
12 Power supply earth connection
13 Motor output earth connection
P1
D1
3
1 2 4
L2
B1
M1
CODES
1 2 3
ANEM
B
15
Pos.1 Pos.2
J1
J2
J3
J4
ON
J1 J2 J3 J4
J5
4 5 6
7
TC TA
B
CS1488 DC0565
L1
F3.15A
8 9 10 11
c
M
L N
A
1