Idiomas disponibles
Idiomas disponibles
EN
near places where water is sprayed.
Place the device only on a hard, even and fl at surface.
Make sure that the ventilation openings in the device housing are not obstructed during and
after operation.
During operation, some elements of the housing may become hot – touching them may
cause burns. For carrying the device use only its handle. The device must be turned off
before carrying it. The on/off switch must be in the off position and the batteries must be
removed from the device.
Observe the maximum pressure of the infl ated products. Use a pressure gauge (built-in or
separate) to control the pressure inside the infl ated product. Exceeding the maximum pres-
sure may cause damage to the infl ated product or even its rupture. Rupturing the product
can cause serious injuries.
Periodically check that the readings of the pressure gauge built into the tool match those of
the calibrated pressure gauge.
Check the tool for damage before each use. If you notice any cracks, abrasions or other
damage, do not use the tool until the defects are removed.
The device is designed for use with fl exible pressure hoses only. The hoses connected to the
device should withstand at least the pressure that the compressor is capable of generating.
Hoses for pressures higher than 7 bar / 0.7 MPa should be equipped with a protective shell,
e.g. in the form of wire ropes.
Before connecting the hose to the device, check that the hose is not damaged. If abrasions,
cracks or air leaks of the insulation are discovered, stop using the damaged hose and re-
place it with a new hose before commencing work.
Never bend or twist the hose during operation. Bending the hose can reduce its inside diam-
eter even to the point where the air fl ow stops. This can lead to damage to the hose or even
to its rupture, which can result in serious injuries. Bending and twisting the hose also speeds
up hose wear. Never carry the tool holding it by the hose. Do not overtension the hose during
operation.
Avoid the creation of long lines for the transfer of compressed air. Shorter lines are easier to
control.
All devices and accessories connected to the compressor should withstand at least the pres-
sure that the compressor is capable of generating.
It is forbidden to adjust or modify the safety valve on your own. The improperly adjusted or
modifi ed safety valve may cause damage to the product, which may result in serious injury.
Do not use the device as an artifi cial respiration device, for spraying any substance or for any
other application not described in the instructions manual.
Never point the air stream towards yourself, other people or animals. Do not use your fi nger
or any other part of the body to check if the device is pumping air.
Make sure that the device is turned off before connecting the hose and accessories to the
device.
The device is not intended to be used by children.
O R I G I N A L
I N S T R U C T I O N S
12
