TEFAL EXPRESS POWER ZONE ANTI-CALC GV74 Serie Manual Del Usuario página 23

1800124245 GV74XX EO_110x154 23/09/11 11:16 Page18
SETTING THE TEMPERATURE AND STEAM OUTPUT ACCORDING TO TYPE OF FABRIC TO BE IRONED:
T
YPE OF FABRICS
Silk, Synthetics
(polyester, acetate, acrylic, polyamide)
Silk, Wool
Linen, cotton
To prime the steam circuit, either
before using the iron for the first
time, or if you have not used the
steam function for a few
minutes, press the steam control
button several times in a row,
holding the iron away from your
- fig.6
clothes . This will enable
any cold water to be ejected
from the steam circuit.
MODE ECO:
Your steam generator iron has an ECO mode function which uses less power whilst still guaranteeing a sufficient steam flow for you to
iron your garments properly. In order to use this function, once the thermostat of your iron has been correctly set (see table above),
position the steam flow setting on the ECO segment
or very creased fabrics, we recommend that you use the maximum steam flow for best results.
Dry ironing
• Do not press the steam control button under the iron handle.
Recommendations: for
fabrics other than linen or
cotton, hold the iron a few
centimetres from the
garment to avoid burning
the fabric.
Refilling the water tank
• When the "tank empty" red warning light flashes
steam. The water tank is empty.
• Unplug the steam generator. Open the tank filler flap
Fill the water tank up without exceeding the MAX level
• Close the water tank filler cover.
• Plug in the steam generator. Press the "OK" button
When the green indicator remains lit, the steam is ready.
SETTING TEMPERATURE
CONTROL
•
••
•••
• Iron temperature setting - fig.9:
- Start with the fabrics to be ironed at a low temperature (•) and finish with those which need
higher temperatures (••• or Max).
- Mixed fibre fabric: set the ironing temperature to the setting for the most delicate fabric.
- Woollen garments: press repeatedly on the steam control button
of steam, without placing the iron on the garment itself.
• Steam output setting:
- Thick fabric: increase the steam setting.
- At a low temperature : set the steam output control dial to the low position.
- fig.12. The ECO mode can be used on all types of fabrics, however, for very thick
• Set the iron temperature control slide and the steam output control dial (located on the control
panel) to the MAX position.
• Hang the garment on a coat hanger and hold the fabric slightly taut with one hand.
As steam is very hot: never attempt to remove creases from a garment while it is being
worn, always hang garments on a coat hanger.
• Holding the iron in a vertical position
steam control button (underneath the iron handle) moving the iron from top to bottom
- fig.10,
- fig.4.
- fig.4.
- fig.11, on the control panel to continue ironing.
Power Zone Function (according to model)
• Your appliance includes the Power Zone function: concentrated steam shot at the tip of the
soleplate, to be used in particular to target stubborn creases, detailing and zones that are
difficult to access.
• To use this function, press the Power Zone function on top of the iron as often as necessary
- fig.7.
Setting the temperature
SETTING STEAM OUTPUT CONTROL DIAL
Vertical steam ironing
- fig.6, tilted slightly forwards, press repeatedly on the
it means that you have no more
FR
NL
DE
EN
IT
ES
DA
SV
- fig.6 to obtain short bursts
FI
NO
EL
TR
PL
CS
SK
HU
RU
UK
- fig.8.
HR
RO
BG
SL
ET
LT
LV
18