Idiomas disponibles
Idiomas disponibles
Trouble or fault
The rotary hammer drill or the
battery gets very hot.
Accessory tool cannot be
released from the chuck.
Accessory tool makes no
progress.
10
Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti sales representative for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!
11
Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
12
Further information
For more information on operation,
qr.hilti.com/manual/?id=0000000
This link is also to be found at the end of the documentation, in the form of a QR code.
Mode d'emploi original
1
Indications relatives au mode d'emploi
1.1
À propos de ce mode d'emploi
•
Avant de mettre l'appareil en marche, lire impérativement ce mode d'emploi.
préalablement requise pour assurer la sécurité du travail et un maniement sans perturbations.
•
Bien respecter les consignes de sécurité et les avertissements du présent mode d'emploi ainsi que celles
figurant sur le produit.
•
Toujours conserver le mode d'emploi à proximité du produit et uniquement transmettre le produit à des
tiers accompagné de ce mode d'emploi.
*2351801*
Possible cause
Electrical fault
Locking sleeve not pulled back
fully.
The rotary hammer drill has been
set to reverse rotation.
The function switch is set to
"Drilling without hammering"
technology,
2351801
Action to be taken
▶ Switch off the rotary hammer
drill immediately. Remove
the battery and keep it under
observation. Allow it to cool
down. Contact Hilti service.
▶ Pull the locking sleeve back as
far as it will go and remove the
accessory tool.
▶ Switch the forward/reverse
switch to the "Forward" posi-
tion.
▶ Set the function switch to
.
"Hammer drilling"
environment and recycling,
.
follow this link:
C'est la condition
Français
13
