RIDGID SeeSnake microREEL APX Manual Del Operador página 13

Connecting to the CSx Via
The CSx Via Wi-Fi inspection device can be
connected to the microREEL through the
slip-ring cavity. Remove the slip-ring assem-
bly from the microREEL and install the CSx
Via into the slip-ring cavity.
For more instructions on installing the CSx
Via, refer to the operator's manual.
Retrieving the Camera
Pull the push cable back out of the pipe with
slow, steady force and feed small lengths
back into the drum. Wipe the push cable
with a paper towel or rag as you retrieve it.
Do not exert excessive
NOTICE
force or pull at sharp an-
gles.
lengths or forcing the
push cable may cause it
to loop, kink, or break.
Pipe Guides
Pipe guides center the camera in the pipe,
improve picture quality, and help keep the
lens clear. Use pipe guides when possible
to reduce wear and tear on the camera sys-
tem.
micro CA-350 Inspection
Camera
The microREEL CA can be used with the
RIDGID micro CA-350 inspection camera
by installing the micro-CA 350 adapter that
comes with the CA model.
For instructions on connecting the micro
CA-350 to the microREEL, refer to the in-
cluded micro CA-350 adapter instructions or
visit support.seesnake.com/ca350.
Feeding longer
microREEL APX / microREEL CA – English – 13
Removing the Slip Ring
Assembly
1. Disconnect the system cable from the
reporting monitor and remove the mon-
itor from the docking system.
2. Unwrap the system cable from the
cable wraps.
3. Pop the frame cable anchor off the
frame and unhook the system cable
from the frame hook.
4. Turn the slip-ring dial counter-clock-
wise to the unlocked position .
5. Pull straight out.
Do not touch the contact
NOTICE
pins inside the slip-ring
dial. Stressing the con-
tact pins can cause them
to break.