Inspection Overview; Pipe Guides; Maintenance And Support Cleaning; Maintaining Components - RIDGID SeeSnake Standard Manual Del Operador

Inspection Overview

To perform a pipe inspection, connect any See Snake mon-
itor to the reel, power on the system, push the push cable
through the pipe, and observe the display.
For advanced inspection options, such as capturing media,
locating the sonde, tracing the push cable, and delivering
reports, refer to the manual that comes with your monitor.
Connecting to the Monitor
Connect the system cable to the monitor by aligning the
connector guide pin with the socket and pushing the con-
nector straight in.
Only twist the outer locking sleeve.
NOTICE
Never bend or twist the connector.
Socket Guide Pin
Outer Locking Sleeve
Retrieving the Camera
Pull the push cable back out of the pipe with slow, steady
force and feed small lengths back into the drum. Wipe the
push cable with a paper towel or rag as you retrieve it.
Do not exert excessive force or pull at
NOTICE
sharp angles. Feeding longer lengths or
forcing the push cable may cause it to
loop, kink, or break.

Pipe Guides

Pipe guides center the camera in the pipe, improve picture
quality, and help keep the lens clear. Use pipe guides when
possible to reduce wear and tear on the camera system.
10 – English – SeeSnake Standard
Find Quality Products Online at:
Connector Ridge
GlobalTestSupply
www.
Maintenance and Support
Cleaning
Clean your system with rags and a soft nylon brush. If de-
sired, a mild detergent or disinfectant can be used. Do not
use solvents or high pressure water to clean any part of the
system.

Maintaining Components

Camera Head
Scratches on the camera have a minimal effect on its per-
formance. Do not use scraping tools or sand the camera to
remove scratches.
Push Cable
Run a rag over the push cable and visually inspect it for cuts
and abrasions while pushing it back into the drum. Replace
or repair the push cable if the outer jacket is cut or abraded.

Storage

The SeeSnake Standard must be stored in a dry, secure
area between -10°C and 70°C [14°F and 158°F]. Store your
equipment in a locked area out of the reach of children and
people unfamiliar with its purpose.
.com
[email protected]