Idiomas disponibles
Idiomas disponibles
9. TROUBLESHOOTING
The system is equipped with a self-diagnostic of the hardware at the startup.
If any error shows up, unplug the extruder and restart. If the error persists,
contact an authorized service center.
Example of startup diagnostic error:
C:0
Once the start-up check is over, a new self-diagnostic system is initialized
The display may show at any time the following:
#
Err description
No feedback from the temperature sensors.
Probable cause:
5
temperature controller fault.
Contact an authorized service center
Cannot stabilize the melting chamber temperature.
Probable causes:
a.
Sudden change of working conditions (e.g. too much or too low
10
output)
b.
Temperature probe fault.
Turn off/on the extruder.
If the error persists, contact an authorized service center
Cannot stabilize the blower air temperature
Probable causes:
a.
Sudden change of working conditions (e.g. the blower hose is
clogged)
15
b.
Temperature probe fault.
Turn off/on the extruder and make sure that the air flow is not
clogged.
If the error persists, contact an authorized service center
The melting chamber temperature is too high
20
contact an authorized service center
The blower air temperature is too high
25
contact an authorized service center
Cannot control the blower
30
contact an authorized service center
The wiring bow temperature is too high (above 95°C/200F)
35
Make sure that the environmental conditions are suitable to the
extruder (e.g. avoid direct sunlight, etc..)
CHK 4
R:0
ERR: 0
The technical characteristics of the extruder and the data shown in this
manual may be changed without prior notice at the discretion of the
manufacturer.
Spare parts and technical documentation are available online:
www.ritmo.cloud.
Help in the event of problems:
S.p.A.
via A. Volta, 35/37 - Z.I. Selve
35037 BRESSEO DI TEOLO (PD)
ITALY
Tel. +39.049.990.1888
Fax +39.049.990.1993
Disposal
Do not dispose of in the household trash. Add the device that is no
longer able to be used to a separate collection for the purpose of
environmentally friendly recycling.
EN
19
