Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Simultaneously insert the filler wire into the appropriate hole. Leave the
extrudate to come out of the tip hose for about 10 seconds and make sure
that it is plasticized correctly, then proceed with welding.
Make sure the extrudate is flowing smoothly.
Filler wire
OPERATING INSTRUCTIONS
• Place the shoe on the two sheets to be welded (example X and Y). Preheat
the welding area for a few seconds before starting the extrusion.
• Apply some pressure while moving the extruder.
• Follow the welding direction as indicated by the arrow in the figure. The
blowing of hot air for the preheating of the material must always precede
the supply of the extruded material. An incorrect preheating does not
guarantee the interpenetration of the filler material with the sheets to be
welded ("gluing effect").
Warning! Prevent the extruded material from invading the preheated area
and blocking the hot air duct.
Y
X
WARNING! Do not let any electrical wire come into direct
contact with neither the extruded nor the hot surfaces!
LINERS – GEOTEXTILES
If the sheets to be welded are very thin, it is possible to decrease the blower
flow.
Decrease the air temperature below 225°C: the display will show a flashing
'225°C/OFF' while air flow slows down.
225 [OFF]
2
3
At the end of welding, place the extruder on the appropriate support.
SHUTDOWN
Push buttons 6 and 7 together: the air temperature decreases to cool down
the heating resistors, while a countdown starts on the display.
Please wait 97 sec
7
6
CAUTION! The shutdown procedure does not provide for the complete
cooling of the various hot parts of the extruder but only serves to lower the
temperature of the heating resistors to ensure a longer duration. To avoid
accidental burns, wait for the parts to cool naturally.
READY!
215
COOLING
EN
17
Tabla de contenido
