Ritmo STARGUN Manual De Uso Y Mantenimiento página 13

Idiomas disponibles

Idiomas disponibles

5. SAFETY CRITERIA
The use of STARGUN is reserved exclusively for trained and suitably skilled
personnel in accordance with the regulations in force.
Use the extruder exclusively for the purpose described in section Field of
application" and in accordance with the operating and maintenance
instructions. Any other type of utilization is considered as improper use and
therefore prohibited because of the risk of serious injury of operators, other
persons and/or damage to the extruder and other property.
Immediately replace all worn or damaged parts using exclusively ritmo
original spare parts.
All repairs on the extruder must be performed by skilled and qualified
personnel.
Context:
MOTOR & BLOWER
SHOCKING
HAZARD
Check that the electrical characteristics of the extruder correspond to
the
specifications of the power supply line.
During connection phase between electrical board and electrical line,
verify the presence of safety differential and magneto-thermal devices
on electrical supply line.
If necessary, proceed with calibration. Inlets on electrical board must be
of type IEC 309 with minimum protection grade IP44. Do not expose the
extruder to rain or other liquids.
Make sure that isolating protections (for example gloves) are always
perfectly dry.
Do not expose electrical wiring or hydraulic hoses to chemical
substances or mechanical stress (e.g. pedestrian or vehicular traffic,
contact with sharp objects, pulling, etc.).
Disconnect the power socket outlet from the electrical power supply
when work with the extruder has been concluded or temporarily
suspended. Before using the extruder check the condition of individual
electrical system components, particularly insulating parts, cables, cable
glands and cable jaws.
Clean the extruder thoroughly after each session. Avoid the use of
solvent, petrol and abrasive substances which could damage insulated
parts of the extruder.
Connection cable must agree to regulation and
required power.
Connection must be done with plug IEC 309, IP67.
20 A 230-250V.
Small or humid places, building sites surrounded by metallic masses or
water (for example shipyards) require use of equipment fed in SELV
(very low safety tensions).
Context:
BLOWER, MELTING
CHAMBER AND
WELDING SHOE
RISK OF BURNING
Handle the extruder carefully.
Do not touch welding bead and near areas before complete cooling.
CHECK GROUND
CONNECTION
FIRE HAZARD
Do not use the extruder in presence of explosive gases and vapors.
Keep away from extruder materials that can deteriorate with heat
inflammable (oil, solvents, etc.).
NIOSE EXPOSURE
Do not weld sheets, pipes or fittings that contain or have previously contained
toxic substances.
Use carefully those chemical substances used during preparations before
welding:
Stay away from flames or hot surfaces;
USE
Do not smoke;
PROTECTION
Ventilate the work place.
GLOVES
Context: MOTOR AND BLOWER
Context:
MOTOR
Context: SHEETS/PIPES/FITTINGS
CHEMICAL HAZARDS
OTHER FABRICATION MATERIALS
RISK OF EXPLOSION
HOT
BURNING AREA
WEAR EARMUFFS
EN
13
loading