Idiomas disponibles
Idiomas disponibles
Once the cooling countdown is over, the display shows 'OFF'.
2
3
Push together buttons 2 and 3 to turn on the extruder again or unplug it.
WARNING! Always unplug the extruder at the end of working day.
SETTINGS MENU
Hold down button 2 within 6 seconds from connecting the extruder to the
power source to enter the settings menu.
PLEASE WAIT 120
2
If within 6 seconds you cannot access the menu, disconnect the extruder
from the power source, reconnect it and proceed as described above.
7
6
3
Push buttons 6 and 7 to select the menu number to access. Push button 3
to confirm.
Number 0: it displays the MOTOR working hours (..h: ..m) with partial and
total time counter.
XXH
Total working hours
Partial working hours
Number 1: press button 3 to zero the partial time counter above.
Note: The partial counter registers each sec of MOTOR in use and updates
the display value for each 4 1/2 min of use.
Number 2: use to switch between Celsius and Fahrenheit. Use buttons 6
and 7 to select Celsius CEL or Fahrenheit FAR.
Press button 3 to save the settings.
WARNING! The advanced menus (from 3 on) are for factory settings only
18
EN
OFF
HEATING
NUMBER?
0
YYH ZZM
8. MAINTENANCE
Warning
•
Disconnect extruder from electrical line before performing any
maintenance intervention.
Let specialized technicians to perform maintenance on the welder.
•
Before any intervention, wait for the complete cooling of the extruder.
COMMUTATOR/BRUSH SEATER CLEANING
Use a brush seater stone to clean the commutator. Repeat procedure at
least once per brush replacement.
AIR FILTER CLEANING
Pulire periodicamente con pistola ad aria compressa la scatola elettrica in
corrispondenza delle feritoie per l'aria.
Warning
Do not use corrosive detergents
We recommend to clean the STARGUN after every use.
