Idiomas disponibles
Idiomas disponibles
EXTRUDATE TEMPERATURE SETTING
Hold button 7 pressed for 3 sec. Use buttons 6 and 7 to set the air
temperature within the range T min=195°C – T max=260°C. The new setting
point is stored after 5 sec.
7
6
Working temperature
Please refer to standard DVS 2207-4.
CHECKS
Make sure the extrudate-hose is not clogged before triggering the motor.
If necessary, gently remove the extrudate clogging when it's turning soft
with a flat screwdriver tip.
WARNING! Use eyewear. Do not stand in front of the extrudate hose.
P
B
Pull the motor trigger P and button B to start the extruder.
16
EN
CHANGE
220
Simultaneously insert the filler wire into the appropriate hole. Leave the
extrudate to come out of the tip hose for about 10 seconds and make sure
that it is plasticized correctly, then proceed with welding.
Make sure the extrudate is flowing smoothly.
Filler wire
OPERATING INSTRUCTIONS
• Place the shoe on the two sheets to be welded (example X and Y). Preheat
the welding area for a few seconds before starting the extrusion.
• Apply some pressure while moving the extruder.
• Follow the welding direction as indicated by the arrow in the figure. The
blowing of hot air for the preheating of the material must always precede
the supply of the extruded material. An incorrect preheating does not
guarantee the interpenetration of the filler material with the sheets to be
welded ("gluing effect").
Warning! Prevent the extruded material from invading the preheated area
and blocking the hot air duct.
Y
X
