English
26
Problem
The radio does not work.
The radio produces a crackling
sound.
The alarm went off yesterday, but
it did not go off today.
I wanted to snooze, but the
alarm did not go off again after 9
minutes.
The light wakes me too early.
The light wakes me too late.
Solution
Perhaps you set the volume too low. Increase the volume level.
Perhaps the radio is not tuned to a station. Tune it to a station.
The radio may be defective. Go to www.philips.com/support
or call 1-866-832-4361 for assistance.
Perhaps the broadcast signal is weak. Adjust the frequency and/or
change the position of the antenna by moving it around. Make sure
you have unwound the antenna completely.
Perhaps you switched off the alarm function.The alarm icon is
visible on the display when the alarm function is active.
Perhaps you set a volume level and/or light intensity level that is
too low. Set a higher volume level and/or light intensity level in
your wake-up profile.
Perhaps there was a power failure that lasted longer than the time
backup. The set clock time is lost. You have to set the correct clock
time again.
Tap on the top of the Wake-Up Light to snooze. If you press the
alarm button, the FM button, or the MENU button, the alarm
function will be deactivated.
Perhaps the light intensity level you have set is not appropriate for you.
Try a lower light intensity level if you wake up too early. If light intensity
1 is not low enough, move the appliance further away from the bed.
Perhaps the appliance is positioned at a lower level than your head.
Make sure the appliance is located at a height at which the light is not
blocked by your bed, duvet or pillow. Also make sure the appliance is
not placed too far away.