Makita DHS782 Manual De Instrucciones página 10

Bevel cutting
CAUTION:
After adjusting the bevel angle,
always tighten the clamping screws securely.
Loosen the clamping screws. Set for the desired angle
1. Clamping screw
45° bevel cut or 0° - 48° bevel cut.
0° - 45°
0° - 48°
1. Stopper
Sighting
For straight cuts, align the 0° position on the front of the
45° position with it.
1. Cutting line (0° position) 2. Cutting line (45° position)
Lighting the lamp
1
CAUTION:
source of light directly.
To turn on the lamp without running the tool, pull the
To turn on the lamp with the tool running, press and hold
The lamp goes out 10 seconds after releasing the switch trigger.
1
1. Lamp
NOTE:
the lamp. Be careful not to scratch the lens of lamp, or
Hook
Optional accessory
CAUTION:
hanging the tool with the hook.
CAUTION:
tions or on the surfaces where the tool may lose
the balance and fall.
CAUTION:
when it is hooked.
10 ENGLISH
1
Do not look in the light or see the
1
Always remove the battery when
Never hook the tool at high loca-
Do not pull the tool downward
2