Makita DHS782 Manual De Instrucciones página 21

MAINTENANCE
CAUTION:
Always be sure that the tool is
before attempting to perform inspection or
maintenance.
CAUTION:
Clean out the upper and lower
guards to ensure there is no accumulated saw-
dust which may impede the operation of the lower
guarding system.
the proper operation which could result in serious
this cleaning is with compressed air. If the dust is
being blown out of the guards, be sure the proper
eye and breathing protection is used.
CAUTION:
dust on the tool.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY,
Adjusting 0°-cut or 45°-cut accuracy
1.
Loosen the clamping screws on the front and rear
of the tool so that the bevel angle can be changed. Set
1
1. Stopper
2. Make the base perpendicular or 45° to the circular
ing screw with a hex wrench. You can also use a square
1
1. Triangular rule
2
1.
for 45° angle
3. Tighten the clamping screws and then make a test
cut to check if desired angle is obtained.
Adjusting the parallelism
CAUTION:
Keep the parallelism accurate.
1.
Set the tool to the maximum cutting depth.
2. Make sure all levers and screws are tightened.
3.
21 ENGLISH
1
1
2.
-