Troubleshooting - Panasonic EW3002 Instrucciones De Funcionamiento

Troubleshooting

Display Status before error
Pressurization to above
300 mmH was
performed.
(Re-pressurization was
performed several
The "E" blinks on
times.)
the display
Pressure decreased
suddenly and "E"
appeared in the display.
The measurement
process was performed
until 20 mmH was
reached and then "E"
appeared in the display.
Pressurization to above
180 mmH was not
performed.
17
Check points
Check whether
measurements are
being taken correctly
and whether the user
is assuming the
correct posture. Make
sure the unit is on the
palm side of the wrist.
(See pages 9 and 10.)
Check whether the
pressure cuff is
attached to your wrist
correctly. Make sure
the unit is on the palm
side of the wrist.
(See pages 9 and 10.)
Symptom
The systolic pressure • The hand with the cuff was held too low and
value or diastolic not at heart level. (See page 10.)
pressure value is high.
• The cuff was not attached properly. (See
page 9.)
• You moved your hand or body or you spoke
during measurement. (See page 10.)
The systolic pressure • The hand with the cuff was held too high
value or diastolic and not at heart level. (See page 10.)
pressure value is low.
• You moved your hand or body or you spoke
during measurement. (See page 10.)
The measured values • Your posture was not the same for all
differ significantly. measurements, or measurements were
taken without sufficient time in between.
Always wait approximately 5 minutes before
taking another reading, and above all, relax.
The measured value • Blood pressure varies in response to minute
differs from that changes in your mental state, such as your
measured by the doctor. reaction to your doctor taking the
The measured value is measurement. One way to check this is to
different for each bring the unit to your doctor's office and
measurement. directly compare the readings taken by your
physician.
• Relax for at least 5 minutes and then take
another measurement.
The measured value • For persons with certain circulation
obtained is different from problems, there may be substantial
that measured at the differences in blood pressure values
upper arm. measured at the upper arm versus at the
wrist.
If the device still appears to provide unusual or erroneous readings,
consult your physician. If the device does not appear to be functioning
properly, contact Panasonic at 1-800-338-0552.
Possible cause
18