Troubleshooting - Panasonic EW3036 Instrucciones De Operación

EW3036EU̲25-45 05.2.17 7:55 PM ページ 42

Troubleshooting

Display Symptom prior to error display
Pressure has exceeded
280 mmHg.
(The device repressurizes
repeatedly.)
A flashing "E"
Pressure has suddenly
is displayed.
dropped.
Heart mark
a couple of times or not at
all.
Pressure cuff does not
inflate.
Solution
Are you carrying out
measurement properly
and in the correct
position?
(Please see page 33~34.)
flashed only
Have you positioned the
pressure cuff correctly?
(Please see page 32.)
42
Symptom
The SYS or DIA is • The pressure cuff is positioned too low.
high. (Please see page 33~34.)
• The pressure cuff is not wrapped around the wrist
properly. (Please see page 32.)
• The person is moving or talking when the measurement
is being carried out. (Please see page 33~34.)
The SYS or DIA is • The position of the pressure cuff is too high.
low. (Please see page 33~34.)
• The person is moving or talking when the measurement
is being carried out. (Please see page 33~34.)
Blood pressure is • The posture of the person is different each time
abnormally high measurements are carried out.
or low. (Please see page 33~34.)
Measurements are • The person is slightly tense when with the healthcare
different from professional, causing the measurements to be
those taken by a different.
doctor. • Relax for ten minutes and then carry out the
Measurements are measurement again.
different each time.
Measurements • There may be major differences in blood pressure
are different from recorded at the wrist and on the upper arm for
those obtained people with peripheral circulatory problems.
using an upper
arm type blood
pressure meter.
If the meter still appears to provide unusual or erroneous readings, consult
your physician. If the meter does not appear to be functioning properly,
contact an authorized service center.
GB
Possible cause
43